Skoda Workshop Service and Repair Manuals > Octavia Mk1 > Power transmission | Automatic gearbox 01M | Automatic gearbox, gears, control | Removing and installing the slide valve body | Actuator rod for manual slider - replacing steel spring and screw for shift shaft

Adjust actuator rod for manual slider

Note

The screw with steel spring must be replaced after each disassembly → Chapter.

–	Shift the shift shaft into position “P”.

–	Insert the actuator rod with manuel slider into the slide valve body up to the stop -direction of arrow- and tighten the screw for the lever.

l	Tightening torque: 4 Nm.

Note

t	The manual slider must lie against the stop in the slide valve body for adjusting. Counterhold the screw when tightening in -direction of arrow-.

t	Do not press on the small limiting lever of the steel spring, otherwise the adjustment is inaccurate.

t	Inspection: In selector lever position “1” the manuel slider must be flush with the outside of the slide valve body.