skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket ring between angle gearbox and gearbox on installed gearbox (Octavia II, Superb II) > < Removing

Octavia Mk2

Install
Install
–  Lightly oil new gasket ring at outer surface.
   
–  Drive in the new gasket ring with thrust piece -T10049- up to the stop, do not twist the new gasket ring.
–  Fill half the space between the sealing lip and dust lip with sealing grease -G 052 128 A1-.
  N39-0764
–  Remove gasket ring -A- from the groove -arrow- of the flange shaft and replace → Chapter.
–  Carefully drive in flange shaft (slowly turn flange shaft).
–  Secure the flange shaft with new conical screw and tighten to tightening torque.
–  On vehicles with particle filter install the bracket for the particle filter, if it was removed → Engine; Rep. gr.26.
–  Install right drive shaft → Chassis; Rep. gr.40.
  N39-10211
–  Install cap for drive shaft -arrows-, if it was removed.
–  Inspecting oil level in the angle gearbox → Chapter.
–  Install the front right wheelhouse liner → Body Work; Rep. gr.66.
–  Install the noise insulation → Body Work; Rep. gr.50.
–  Attach the right front wheel → Chassis; Rep. gr.44.
  A39-0277
Tightening torques
ComponentNm
Flange shaft on gearbox (conical screw)1)Octavia II → Chapter
Superb II → Chapter
Yeti → Chapter
Protective cap drive shaft on angle gearboxOctavia II, Superb II → Chapter
Yeti → Chapter, or → Chapter

1) Always replace screw → Electronic Catalogue of Original Parts.
   

Replacing gasket ring between angle gearbox and gearbox on installed gearbox (Octavia II, Superb II) > < Removing