Octavia Mk2
| 1 - | Gearbox housing |
| q | when replacing: set the drive shaft and the differential gear |
| 2 - | Needle bearing |
| q | for output shaft |
| q | removing → Fig. |
| q | fitting and securing → Fig. |
| 3 - | Oil filler plug, 30 Nm |
| q | without magnet |
| q | the gear oil level can no longer be checked by unscrewing this plug → Chapter |
| 4 - | Outer ring/tapered-roller bearing |
| q | for output shaft |
| q | removing and installing → Chapter |
| q | when replacing: set the output shaft → Chapter |
| 5 - | Adjusting washer |
| q | for output shaft |
| q | Setting overview → Chapter |
| 6 - | Adjusting washer |
| q | for drive shaft |
| q | Setting overview → Chapter |
| 7 - | Outer ring/tapered-roller bearing |
| q | for drive shaft |
| q | removing and installing → Chapter |
| q | when replacing: set the drive shaft → Chapter |
| 8 - | Outer ring/tapered-roller bearing |
| q | for drive shaft |
| q | removing and installing → Chapter |
| q | when replacing: set the drive shaft → Chapter |
| 9 - | Needle bushing |
| q | removing and installing → Chapter |
| 10 - | Fitting sleeve |
| q | (2 pieces) |
| 11 - | Clutch housing |
| 12 - | Guide bushing |
| q | with gasket ring for the drive shaft and vulcanized O-ring |
| q | Driving out gasket ring → Fig. |
| q | Driving in gasket ring → Fig. |
| q | to replace gasket ring remove guide bushing |
| q | if O-ring is damaged, replace guide bushing and O-ring together → Electronic Catalogue of Original Parts |
| 13 - | 20 Nm |
| q | self-locking |
| q | always replace → Electronic Catalogue of Original Parts |
| 14 - | Sealing ring |
| q | replace → Chapter |
| 15 - | Oil drain plug, 30 Nm |
| q | without magnet |
| 16 - | Outer ring/tapered-roller bearing |
| q | for differential gear |
| q | pressing in and pressing out → Chapter |
| q | when replacing: Set the differential gear → Chapter |
| 17 - | Magnet |
| q | is held in position by the separator surface of the housing |
| 18 - | Oil drip pan |
| q | Install oil drip pan in the gearbox housing |
| 19 - | Outer ring/tapered-roller bearing |
| q | for differential gear |
| q | pressing in and pressing out → Chapter |
| q | when replacing: Set the differential gear → Chapter |
| 20 - | Adjusting washer |
| q | for differential gear |
| q | Setting overview → Chapter |
| 21 - | Sealing ring |
| q | replace → Chapter |
