If the round piece of the tube-hoseline -1- is directly installed underneath the master cylinder, this line must be removed.
Note
When performing the following work, make sure that no brake fluid comes into contact with the frame side rail or the gearbox. If this is the case, these points must be cleaned thoroughly.
–
Pinch off return hose to master cylinder with hose clamp -MP7-602 (3094)- (if the return hose is made out of plastic, do not use the hose clamp -MP7–602-, otherwise the return hose can get damaged).
–
Remove inlet hose -3- at master cylinder (remove plastic return hose -3- at master cylinder and close with a suitable tool e.g. -T10249/1-).
–
Unlock locking clip -2- with a screwdriver and detach tube-hose line -1- at master cylinder.
–
Clip off clutch position sender -G476- at master cylinder -arrow- and remove with attached connector -4-.
Install
Installation is performed in the reverse order, pay attention to the following points: