skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Ignition system, glow plug system > < Removing and installing parts of the exhaust gas recirculation system

Superb

Vehicles between with clamping sleeve between middle and rear silencer
Vehicles between with clamping sleeve between middle and rear silencer
  Note
The second clamping sleeve between middle and rear silencer is additionally mounted, if the middle or rear silencer is replaced separately.
–  Slacken screws on both clamping sleeves.
   
The arrows in the figures point to the front.
–  Push the middle silencer forward until the dimension -a- = 5 ... 9 mm is obtained on the hanger/middle silencer (right half of image).
–  Tighten screws of clamping sleeve in front of middle silencer.
–  Push the rear silencer forward until the dimension -a- = 7 ... 11 mm is obtained on the hanger behind the rear silencer (left half of image).
–  Check alignment of exhaust tail pipes to body and tighten screws of clamping sleeve between middle and rear silencer.
  N26-0390

Ignition system, glow plug system > < Removing and installing parts of the exhaust gas recirculation system