Superb
Disassembling and assembling oil filter holder |
1 - | Screw plug, 40 Nm |
2 - | Gasket ring |
q | Cut open gasket ring if leaking and replace |
3 - | Spring |
q | for pressure relief valve approx. 0.4 MPa (4 bar) |
4 - | Piston |
q | for pressure relief valve approx. 0.4 MPa (4 bar) |
5 - | Gasket |
q | replace |
6 - | Gasket ring |
q | push on as far as collar on the tube → Item |
7 - | Pipe |
8 - | Retaining clip |
9 - | Screw plug, 15 Nm |
10 - | Gasket ring |
q | Cut open gasket ring if leaking and replace |
11 - | 20 Nm |
12 - | Coolant pipe below |
13 - | Oil feed line |
q | to exhaust turbocharger |
14 - | Hollow screw, 30 Nm |
15 - | Gasket |
q | replace |
16 - | Oil pressure switch 0.14 MPa (1.4 bar) -F1-, 25 Nm |
q | check → Chapter |
17 - | Gasket ring |
q | Cut open gasket ring if leaking and replace |
18 - | 15 Nm + torque a further + 90 ° (1/4 turn) |
q | replace |
19 - | Gasket |
q | replace |
q | fit into the grooves on the oil cooler |
20 - | Oil filter |
q | slacken with tensioning strap |
q | tighten by hand |
q | pay attention to installation instructions on oil filter |
21 - | 25 Nm |
22 - | Oil cooler |
q | ensure clearance to surrounding components |
q | pay attention to the notes → Chapter |
q | Coat the contact surfaces to the oil filter holder outside the gasket ring with AMV 188 100 02 |
23 - | Oil filter holder |
q | with pressure relief valve approx. 0.4 MPa (4 bar) |
q | with interference-fit return-flow check valve |
q | for vehicles ► 06.02: |
The following parts must be replaced if leaks are found in the area of the connection of the oil feed line ( → Item) to the oil filter holder. the complete holder, oil feed line, hollow screw and gasket rings |