Repairing the gearbox housing

Make

Skoda

Model

Superb

Section

Manual gearbox 01E › Gearbox mechanics,operation, construction,diff. › Repairing the gearbox housing

Power transmissionRepairing the gearbox housing

Disassembling and assembling the complete gearshift shaft

1 -	Shift cylinder

2 -	Tensioning sleeve

q	always replace → Electronic Catalogue of Original Parts

q	extracting and inserting → Fig. flush

q	Tensioning sleeve fitting position: slot longitudinally to power flow

3 -	Gearshift shaft

q	drive out of shift cylinder Pos. 1 → Fig.

q	drive into shift cylinder Pos. 1 → Fig.

q	Fitting position: Flattened part -arrow- and shift finger Pos.4 point in the same direction

4 -	Shift finger

q	Pay attention to the fitting position of the gearshift shaft Pos. 3

5 -	Cams for reversing lights switch -F4-

Flush mounting/extraction of tensioning sleeve A -  Drift B -  Protective jaws

Driving in the gearshift shaft A -  Drift B -  Protective jaws

Driving in the gearshift shaft    -A- Wooden base   Note t  Bring holes in the gearshift shaft/shift cylinder into line. t  The flattened part on the gearshift shaft -1- and the shift finger -2- of the shift cylinder point in one direction.

06 Transmission