Workshop Manuals Factory service & repair Skoda
01 Engine02 Body03 Heating, Air conditioning04 Chassis05 Drive unit06 Power transmission07 Vehicle electrics08 Heating, ventilation, air conditioning system09 Power unit
Skoda Superb07 · Vehicle electrics
07 · General

Starter

Make
Skoda
Model
Superb
Section
Electrical System › Starter-current supply-CC › Starter
Vehicle electricsStarter
Removing and installing the starter
Removing
–  Switch off ignition.
   
–  Push the battery cover -1- to one side -arrow A- and remove.
–  Disconnect earth strap of the battery.
–  Remove the noise insulation.
–  Bring the lock carrier into the service position for vehicles which have cramped working conditions because of the vehicle equipment → Body Work; Rep. Gr.50.
Diagram not available  Note
t  On certain engines or depending on the vehicle equipments, it may be necessary to loosen the engine mountings and to raise the engine using the supporting device -MP 9-200 - → Engine; Rep. Gr.10.
t  It may also be necessary, depending on the engine and gearbox version, on vehicles which have air conditioning, to loosen the brackets of the refrigerant hoses → Heating, Air conditioning system; Rep. Gr.87.
t  On vehicles fitted with an automatic gearbox it may be necessary, depending on the engine, to loosen or remove the hoses at their brackets from the automatic gearbox to the gearbox oil cooler → Automatic gearbox; Rep. Gr.37.
  N92-0190
–  Unplug connector -1- (terminal 50).
–  Unscrew cable -2- at solenoid switch (terminal 30).
  N27-0060
–  Unscrew the screw clamp -arrow- for attaching the heat shield, if present.
Mounting of the starter on the engine block
Diagram not available  Note
  N27-0088
On certain engines or depending on the gearbox versions, the mounting bracket -arrow C- is not fitted.
–  Unscrew the securing nut -arrow A- (22 Nm).
–  Unscrew the securing nut -arrows B- (4 Nm) and remove the mounting bracket of the starter.
Mounting of the starter on the clutch housing
  N27-0091
–  Remove the screws -1- and -2- (sectional drawing of the clutch housing) from the clutch housing (65 Nm) and remove the starter downwards.
Install
Installation is performed in the reverse order, pay attention to the following points:
–  The tightening torque for terminal 30 of the starter: 16 Nm
–  Pay attention to the work sequence when connecting the battery → Chapter.
  N27-0080

Parts & tools for this job For Skoda Superb

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.