Yeti
| The seat belts at the rear - summary of components |
| 1 - | Inertia reel |
| Removing: |
| – | Removing side trim panel in luggage compartment → Chapter. |
| – | Remove the top deflection fitting -3-. |
| – | Remove the bottom deflection fitting -12-. |
| – | Remove screw -2-. |
| – | Remove the inertia reel. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 2 - | 35 Nm |
| 3 - | Top deflection fitting |
| Removing: |
| – | Removing side trim panel in luggage compartment → Chapter. |
| – | Remove screw -4-. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 4 - | 35 Nm |
| 5 - | Cover for the middle safety belt |
| Removing: |
| – | Unclip cover -6-. |
| – | Remove screws -7-. |
| – | Remove the cover for the middle safety belt. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 6 - | Caps |
| 7 - | 4 Nm |
| 8 - | Inertia reel for the middle safety belt |
| Removing: |
| – | Remove the moulded headliner → Chapter. |
| – | Remove screw -9-. |
| – | Remove the middle inertia reel. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 9 - | 35 Nm |
| 10 - | Belt buckle |
| Removing: |
| – | Fold open rear seat → Chapter. |
| – | Remove screw -11-. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 11 - | 35 Nm |
| 12 - | Deflection fitting below |
| Removing: |
| – | Fold open rear seat → Chapter. |
| – | Partially raise the floor covering under the rear seats. |
| – | Remove screw -13-. |
| – | Remove the bottom deflection fitting. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 13 - | 35 Nm |