Workshop Manuals Factory service & repair Skoda
01 Running gear02 Body03 Power transmission04 Vehicle electrics05 Heating, ventilation, air conditioning system06 Power unit
Skoda Yeti04 · Vehicle electrics
04 · General

Headlights - halogen headlights

Make
Skoda
Model
Yeti
Section
Electrical System › Lights, lamps, switches outside › Headlights - halogen headlights
Vehicle electricsHeadlights - halogen headlights
Replacing bulb for main beam and low beam H4
Diagram not available   WARNING
The H4 light bulb is pressurized and can burst when changing the bulb. It is recommended to wear gloves and safety spectacles when changing the lamps.
Diagram not available  Note
t  Do not touch the glass when installing the light bulb. Your fingers will leave traces of grease on the glass which then evaporate when the bulb is switched on causing it to cloud.
t  When installing the cap, pay attention to the correct fitting. Water ingress can destroy the headlight.
–  Switch off the ignition and all electrical components.
   
–  Turn cap -1--arrow- and remove.
  S94-0321
–  Unplug connector -1-.
–  Press the wire spring clamp -2--arrow- and tilt it out.
–  Remove the defective light bulb -3- and replace it.
  S94-0310

Parts & tools for this job For Skoda Yeti

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.