CAUTION / NOTICE / HINT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPLACEMENT › CAUTION / NOTICE / HINT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
CAUTION / NOTICE / HINT
BRAKE SYSTEM (OTHER) BRAKE FLUID(w/ VSC) REPLACEMENT
CAUTION / NOTICE / HINT
HINT: If any work is performed on the brake system or if air in the brake lines is suspected, bleed the brake system.
NOTICE:
· for Manual Transmission: Move the shift lever to neutral and apply the parking brake before bleeding the brakes.
· for Automatic Transmission: Move the shift lever to P and apply the parking brake before bleeding the brakes.
· Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.
· If brake fluid leaks onto any painted surface, immediately wash it off.
· Bleed the brake line of the wheel farthest from the master cylinder first.
PROCEDURE
1.REPLACE BRAKE FLUID
a. Remove the brake master cylinder reservoir filler cap assembly.
b. Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes. Brake Fluid: except TSAM Made: SAE J1703 or FMVSS No. 116 DOT 3 for TSAM Made: SAE J1704 or FMVSS No. 116 DOT 4
NOTICE: Do not remove the filter from the brake master cylinder reservoir and be sure to fill with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.
c. Loosen the bleeder plug of the front disc brake cylinder RH.
d. Repeatedly depress the brake pedal and bleed the air from the bleeder plug of the front disc brake cylinder RH.
NOTICE: Add fluid as necessary so that the fluid in the reservoir does not decrease below the MIN level.
e. After air is completely bled out, tighten the bleeder plug while depressing the brake pedal. Torque: for 4WD and Pre-Runner : 10.8 N*m (110 kgf*cm, 8 ft.*lbf) for 2WD : 8.3 N*m (85 kgf*cm, 73 in.*lbf)
f. Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
g. Loosen the bleeder plug of the rear disc brake cylinder RH.
h. Repeatedly depress the brake pedal and bleed the air from the bleeder plug of the rear wheel brake cylinder RH.
Parts & tools for this job For Toyota Hilux
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
- TOOLBrake line flaring toolSearch: brake line flaring tool
As an Amazon Associate we earn from qualifying purchases.