PRECAUTION - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REMOVAL › PRECAUTION - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
PRECAUTION

· Supply pump assembly
· Common rail assembly
· No. 1 injection pipe sub-assembly
· Cylinder block sub-assembly
· No. 2 injection pipe sub-assembly
· Cylinder head sub-assembly
· Fuel inlet pipe sub-assembly
· Cylinder head gasket
· Timing chain case assembly
· After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
· The injector assembly is a precision instrument. Do not use the injector assembly if it is struck or dropped.
· Make sure foreign matter does not enter the fuel path.
PROCEDURE
1. PRECAUTION
NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
51410
3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)
4.DRAIN ENGINE COOLANT
5.REMOVE FRONT BUMPER
12601B
6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
16593
7.REMOVE NO. 1 RADIATOR AIR GUIDE
17344E
8.REMOVE NO. 4 AIR HOSE
17362B
9.REMOVE NO. 2 AIR TUBE
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.