6.INSPECT DRIVE SHAFT BOOTS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- GENERAL MAINTENANCE › 6.INSPECT DRIVE SHAFT BOOTS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
6.INSPECT DRIVE SHAFT BOOTS
| Front propeller shaft | ( | ) |
|---|---|---|
| Propeller shaft | ( | ) |
b. Tighten the bolts of the propeller shaft.
| Type | See procedure |
|---|---|
| Front propeller shaft | ( ) |
| Propeller shaft | ( ) |
6.INSPECT DRIVE SHAFT BOOTS
a. Check the drive shaft boots for loose clamps, grease leakage, kinks or damage.
7.INSPECT BALL JOINTS AND DUST COVERS
a. Inspect the ball joints for excessive looseness.
i. Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires. ii. Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety. iii. Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels. iv. Using a lever, pry up the end of the lower arm. Check the amount of play. Maximum ball joint vertical play: 0 mm (0 in.) If there is any play, replace the ball joint.
b. Check the dust cover for damage.
8.INSPECT MANUAL TRANSMISSION OIL
a. Visually check the transmission for fluid leaks. If fluid is leaking, find the cause and repair it.
| Type | See procedure |
|---|---|
| R151 | ( ) |
| R151F | ( ) |
| RC60 / RC61 | ( ) |
| RC60F / RC61F | ( ) |
9.REPLACE MANUAL TRANSMISSION OIL
a. Replace the manual transmission fluid.
| Type | See procedure | |
|---|---|---|
| R151 | ( | ) |
| R151F | ( | ) |
| RC60 / RC61 | ( | ) |
Parts & tools for this job For Toyota Hilux
- PARTWheel bearingSearch: Toyota Hilux wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Toyota Hilux cv boot kit
As an Amazon Associate we earn from qualifying purchases.