COOLANT - REPLACEMENT: 3.ADD ENGINE COOLANT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPLACEMENT › COOLANT - REPLACEMENT: 3.ADD ENGINE COOLANT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
COOLANT - REPLACEMENT: 3.ADD ENGINE COOLANT

*5 Radiator Drain Cock Plug - -
HINT: Collect the engine coolant in a container and dispose of it according to the regulations in your area.
c.

Using a wrench, remove the vent plug and radiator reservoir cap sub-assembly, and then drain the engine coolant.
d. Loosen the cylinder block drain cock plug.
e.

Slide the hose clamp and remove the vent plug, and then drain the engine coolant from the water by-pass pipe assembly.
f. Tighten the cylinder block drain cock plug. Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)
g. Tighten the radiator drain cock plug by hand and remove the hose from the radiator drain cock.
3.ADD ENGINE COOLANT
CAUTION:
· Do not remove the radiator reservoir cap sub-assembly, vent plug, radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
· To prevent injury due to contact with an operating fan and generator V belt or cooling fan, keep your hands and clothing away from the fan and generator V belt and the fan when working in the engine compartment with the engine running or the ignition switch to ON.
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.