REPLACE ECM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- Clutch Switch Circuit › REPLACE ECM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
REPLACE ECM

a. for 1GD-FTV, 2GD-FTV
i. Disconnect the B1 clutch switch assembly connector. ii. Disconnect the C57 ECM connector. iii. Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Specified Condition Connection Condition B1-2 - C57-14 Always Below 1 Ω (D) B1-2 or C57- 10 kΩ or 14 (D) - Body Always higher ground
b. for 2TR-FE
i. Disconnect the B1 clutch switch assembly connector. ii. Disconnect the G45 ECM connector. iii. Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Specified Condition Connection Condition B1-2 - G45-18 Always Below 1 Ω (D) B1-2 or G45- 10 kΩ or 18 (D) - Body Always higher ground
Result: Proceed to
NG
REPLACE ECM
for 2TR-FE: Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>ECM>REMOVAL for 1GD-FTV: Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECM>REMOVAL for 2GD-FTV: Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECM>REMOVAL NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Parts & tools for this job For Toyota Hilux
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.