1.REMOVE CAMSHAFT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REMOVAL › 1.REMOVE CAMSHAFT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
1.REMOVE CAMSHAFT

Replaced Parts (A) Pipes Requiring New Replacement
· No. 1 injection pipe sub-assembly Injector assembly (including shuffling the
· No. 2 injection pipe sub-assembly injector assemblies between the cylinders)
· Supply pump assembly
· Common rail assembly
· No. 1 injection pipe sub-assembly
· Cylinder block sub-assembly
· No. 2 injection pipe sub-assembly
· Cylinder head sub-assembly
· Fuel inlet pipe sub-assembly
· Cylinder head gasket
· Timing chain case assembly
· After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
· The injector assembly is a precision instrument. Do not use the injector assembly if it is struck or dropped.
· The supply pump assembly is a precision instrument. Do not use the supply pump assembly if it is struck or dropped.
· Hold the supply pump assembly itself during removal and installation. Do not hold the pre-stroke control valve or fuel pipe, etc.
· Make sure foreign matter does not enter the fuel path.
PROCEDURE
1.REMOVE CAMSHAFT
11310
2.REMOVE TIMING CHAIN COVER ASSEMBLY
13801
3.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
13750
4.REMOVE VALVE LASH ADJUSTER ASSEMBLY
11101
5.REMOVE CYLINDER HEAD SUB-ASSEMBLY
a.

Uniformly loosen the 10 cylinder head set bolts in several passes in the sequence shown in the illustration. Then remove the 10 cylinder head set bolts and 6 cylinder head set bolt spacers.
NOTICE:
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.