DISPOSAL - .pdf: SYSTEMS>STEERING PAD>DISPOSAL - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- .pdf › DISPOSAL - .pdf: SYSTEMS>STEERING PAD>DISPOSAL - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
DISPOSAL - .pdf: SYSTEMS>STEERING PAD>DISPOSAL

73920A
2.DISPOSE OF FRONT SEAT AIRBAG ASSEMBLY LH (When Installed in Vehicle)
NOTICE:
· When disposing of the front seat airbag assembly LH, use an unneeded vehicle to deploy the airbag.
· Be sure to observe the following procedure when deploying the airbag.
HINT: Prepare a battery as the power source to deploy the airbag.
a. Check the function of SST.

SYSTEMS>STEERING PAD>DISPOSAL
SST 09082-00700
b. Refer to Precaution. SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
c. Disconnect the cable from the negative (-) battery terminal.
CAUTION:

· Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
· If the airbag deploys for any reason, it may cause a serious accident.
d. Disconnect the airbag connector.

NOTICE: When disconnecting any airbag connector, take care not to damage the airbag wire harness.
i. Push down the housing lock and slide the CPA. (At this time, the airbag connector cannot be disconnected yet.) ii. Push down the housing lock again and disconnect the airbag connector.
NOTICE: Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.
Parts & tools for this job For Toyota Hilux
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Toyota power steering fluid
As an Amazon Associate we earn from qualifying purchases.