WIRING DIAGRAM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- Cranking Holding Function Circuit › WIRING DIAGRAM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
WIRING DIAGRAM

1GD-FTV ENGINE CONTROL ECD SYSTEM Cranking Holding Function Circuit DESCRIPTION
While the engine is being cranked, current flows from terminal STAR of the certification ECU (smart key ECU assembly) to the park/neutral position switch assembly*1 or clutch start switch*2 and to terminal STA of the ECM (STA signal).
HINT: *1: for Automatic Transmission *2: for Manual Transmission
WIRING DIAGRAM
Refer to DTC P0617 for w/ Smart Entry and Start System.
CAUTION / NOTICE / HINT
NOTICE:
· Inspect the fuses of circuits related to this system before performing the following inspection procedure.
· After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION).
PROCEDURE
1.CHECK WHETHER ENGINE CAN BE CRANKED
a. Check if the engine can be cranked. Result:
| Result | Proceed to |
|---|---|
| Engine cannot be cranked | A |
| Engine can be cranked | B |
A
2.READ VALUE USING GTS (STARTER SIGNAL)
B
13.READ VALUE USING GTS (STARTER SIGNAL)
2.READ VALUE USING GTS (STARTER SIGNAL)
a. Connect the GTS to DLC3.
b. Turn the ignition switch to ON.
c. Turn the GTS on.
Parts & tools for this job For Toyota Hilux
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
As an Amazon Associate we earn from qualifying purchases.