WIRING DIAGRAM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- MIL Circuit › WIRING DIAGRAM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
WIRING DIAGRAM

1GD-FTV ENGINE CONTROL ECD SYSTEM MIL Circuit DESCRIPTION
The Malfunction Indicator Lamp (MIL) is used to indicate vehicle malfunctions detected by the ECM. The MIL operation can be checked visually. When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off after the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.
WIRING DIAGRAM

PROCEDURE
1.CHECK THAT MIL IS ILLUMINATED
a. Check the illumination condition of the MIL. Result:
| MIL | Condition | Proceed to |
|---|---|---|
| Illuminates → Turns off | Ignition switch to ON → engine is started | A |
| Other than above | - | B |
A
CHECK FOR INTERMITTENT PROBLEMS
INTERMITTENT PROBLEMS
Parts & tools for this job For Toyota Hilux
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
As an Amazon Associate we earn from qualifying purchases.