PILOT QUANTITY LEARNING VALUE CLEAR - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REGISTRATION › PILOT QUANTITY LEARNING VALUE CLEAR - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
PILOT QUANTITY LEARNING VALUE CLEAR
j.

When the screen changes, push "Exit".
k. Turn the GTS off and turn the ignition switch off.
l. Wait for at least 10 seconds.
m. Turn the ignition switch to ON, and then turn the GTS on.
n. Clear the DTCs. Powertrain > Engine and ECT > Clear DTCs Execute
o. Turn the ignition switch off.
NOTICE: Do not disconnect the cable from the negative (-) battery terminal for 30 seconds after turning the ignition switch off.
HINT:
· The EFI-MAIN NO. 1 relay turns off after the learned value is stored in the ECM.
· The EFI-MAIN NO. 1 relay turns off and wait for 30 seconds or more of turning the ignition switch off.
7. PILOT QUANTITY LEARNING VALUE CLEAR
HINT:
· If the atmospheric pressure is below the threshold value, "Pilot Quantity Learning" will not be completed and DTC P062F is stored. After "Pilot Quantity Learning Value Clear" is performed, DTC P062F will not be stored.
· Clear the learned values using the following procedure.
a. Connect the GTS to the DLC3.
b. Turn the ignition switch to ON and turn the GTS on.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.