WIRING DIAGRAM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- Starter Signal Circuit › WIRING DIAGRAM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
WIRING DIAGRAM

1GD-FTV ENGINE CONTROL ECD SYSTEM Starter Signal Circuit DESCRIPTION
While the engine is being cranked, the starter signal is also sent to terminal STA of the ECM. The starter signal mainly performs engine control when the engine is started.
WIRING DIAGRAM
Refer to DTC P0617 for w/o Smart Entry and Start System.
CAUTION / NOTICE / HINT
NOTICE:
· Inspect the fuses for circuits related to this system before performing the following procedure.
· After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION).
HINT: This procedure is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to the problem symptoms table.
PROCEDURE
1.READ VALUE USING GTS (STARTER SIGNAL)
a. Connect the GTS to DLC3.
b. Turn the ignition switch to ON.
c. Turn the GTS on.
d. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Starter Signal. Powertrain > Engine and ECT > Data List Tester Display Starter Signal Execute
e. Check the value displayed on the GTS when the ignition switch is turned to the ON and START positions. OK: Ignition Switch Position Starter Signal ON OFF START ON
Result: Proceed to
Parts & tools for this job For Toyota Hilux
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
As an Amazon Associate we earn from qualifying purchases.