ALL READINESS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- DIAGNOSIS SYSTEM › ALL READINESS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
ALL READINESS
a.

The MIL illuminates when the ignition switch is turned to ON and the engine is not running.
HINT: If the MIL is not illuminated, check the MIL circuit (Click here Engine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>MIL Circuit).
b. When the engine is started, the MIL should turn off. If the MIL remains on, the diagnosis system has detected a malfunction or abnormality in the ECD system.
ALL READINESS
HINT:
· With "All Readiness", you can check whether or not the DTC judgment has been completed by using the GTS.
· Check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.
a. Connect the GTS to the DLC3.
b. Turn the ignition switch to ON.
c. Turn the GTS on.
d. Clear the DTCs. Powertrain > Engine and ECT > Clear DTCs Execute
e. Perform the DTC judgment driving pattern to run the DTC judgment.
f. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness. Powertrain > Engine and ECT > Utility Tester Display All Readiness Execute
g. Input the DTCs to be confirmed.
h. Check the DTC judgment result. Result GTS Display Description
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.