HOOD - REASSEMBLY: DOOR / HATCH HOOD REASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REASSEMBLY › HOOD - REASSEMBLY: DOOR / HATCH HOOD REASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
HOOD - REASSEMBLY: DOOR / HATCH HOOD REASSEMBLY

DOOR / HATCH HOOD REASSEMBLY
PROCEDURE
1.CONNECT WASHER HOSE
a. Attach the clamp to connect the washer hose.

85035
2.INSTALL WASHER NOZZLE SUB-ASSEMBLY
76183
3.INSTALL NO. 1 HOOD BULGE PROTECTOR (w/ Hood Bulge)
a. Clean the No. 1 hood bulge protector installation surface with a non-residue solvent.
b. Apply primer to the No. 1 hood bulge protector installation area on the hood bulge.
NOTICE: Apply primer evenly so that there are no uncoated areas.
c. Remove the peeling paper on a new No. 1 hood bulge protector while making sure not to touch the adhesional surface.
d. Install a new No. 1 hood bulge protector to the hood bulge.
e. Remove the peeling paper from double-sided tape and press the double-sided tape to the side of the hood bulge.
f. Install a new No. 1 hood bulge protector in the position shown in the illustration.
NOTICE:
· Press the double-sided tape on the No. 1 hood bulge protector firmly to attach.
· After the primer dries (3 minutes or more), install the No. 1 hood bulge protector.
· After applying primer, reapply primer after 24 hours elapse.
Parts & tools for this job For Toyota Hilux
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Toyota touch up paint
- PARTPanel clip assortmentSearch: Toyota panel clips assortment
As an Amazon Associate we earn from qualifying purchases.