3.INSPECT REVERSE IDLER GEAR - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- INSPECTION › 3.INSPECT REVERSE IDLER GEAR - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
3.INSPECT REVERSE IDLER GEAR
c.

Check the braking effect of the synchronizer ring.
i. Turn the synchronizer ring in both directions while pushing it against the output shaft cone. Check that the ring locks in both directions. If No. 4 synchronizer ring turns, replace it.
33461
3.INSPECT REVERSE IDLER GEAR
a. Install the reverse idler gear with the reverse idler gear shaft bolt. Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
b.

Using a feeler gauge, measure the thrust clearance. Standard clearance:
0.196 to 0.939 mm (0.0078 to 0.0369 in.) Maximum clearance:
0.939 mm (0.0369 in.) If the clearance is more than the maximum, replace the reverse idler gear shaft, reverse idler gear or transmission case.
c. Remove the reverse idler gear.
Parts & tools for this job For Toyota Hilux
- PARTClutch kitSearch: Toyota Hilux clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Toyota Hilux manual gearbox oil
As an Amazon Associate we earn from qualifying purchases.