7.CHECK ECM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- Speed Signal Circuit › 7.CHECK ECM - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
7.CHECK ECM

a.

Rear view of wire harness connector *a (to Combination Meter Assembly)
Disconnect the combination meter assembly connector.
b. Disconnect the G88*1, G45*2, G85*3, G83*4 or G120*8 ECM connector.
c. Disconnect the G69 certification ECU (smart key ECU assembly) connector.*5
d. Disconnect the G27 body ECU connector.*6
e. Disconnect the G90 TCM connector.*7
f. Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Switch Specified Connection Condition Condition G9-19 (+S) - Ignition switch
4.5 to 14 V Body ground ON
Result: Proceed to
NG
7.CHECK ECM
NG
16.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - RADIO
RECEIVER ASSEMBLY)
7.CHECK ECM
*1: w/ Entry and Start System *2: w/ Body ECU *3: for KD Series Engine, Automatic Transmission *4: w/ Navigation System *5: w/ Audio and Visual System (for Radio and Display Type) *6: w/ Audio and Visual System (for Radio Receiver Type)
Parts & tools for this job For Toyota Hilux
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
As an Amazon Associate we earn from qualifying purchases.