2.REMOVE SPIDER BEARING - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- DISASSEMBLY › 2.REMOVE SPIDER BEARING - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
2.REMOVE SPIDER BEARING
If the pinching portions are installed at different locations than where they were located before disassembly, the rotational balance of the propeller shaft cannot be ensured, which may result in vibrations and noise.

· Make sure that the matchmarks are different enough so that they cannot be confused with each other.
· The location of the pinching portions may differ from the location shown in the illustration, so make sure to confirm and properly place matchmarks according to the vehicle.
c. Using a side cutter or pliers, disconnect the 2 propeller shaft boot clamps.
d. Disconnect the 2 propeller shaft boot clamps from the sleeve yoke.
e. Remove the sleeve yoke, and then remove the rear sliding shaft boot and 2 propeller shaft boot clamps from the propeller shaft.
2.REMOVE SPIDER BEARING
HINT: Use the same procedure for all spiders.
a.

*a Matchmark
Place matchmarks on the flange yoke and propeller shaft.
b. for 2WD and Pre-Runner:
i.

*a Matchmark
Place matchmarks on the center yoke and propeller shaft.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.