13.INSPECT TOTAL PRELOAD - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REASSEMBLY › 13.INSPECT TOTAL PRELOAD - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
13.INSPECT TOTAL PRELOAD

Using a dial indicator, adjust the ring gear backlash until it is within the specification. Standard backlash:
0.13 to 0.18 mm (0.00512 to 0.00708 in.)
HINT:
· The backlash is adjusted by turning the left and right adjusting nuts an equal amount. For example, loosen the nut on the right side one notch and loosen the nut on the left side one notch.
· Perform the measurement at 3 or more positions around the circumference of the differential ring gear.
h.

Tighten the bearing cap bolts. Torque:
85.3 N*m (870 kgf*cm, 63 ft.*lbf)
13.INSPECT TOTAL PRELOAD
a.

Using a torque wrench, measure the preload with the teeth of the drive pinion and ring gear in contact.
b. Using a torque wrench, measure the total preload. Standard Total Preload:
| Reduction Ratio | Item | Specified Condition |
|---|---|---|
| 3.583 | New bearing | 1.38 to 2.69 N*m (15 to 27 kgf*cm, 13 to 23 in.*lbf) |
| 3.583 | Reused bearing | 1.38 to 2.46 N*m (15 to 25 kgf*cm, 13 to |
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.