4.REMOVE STEERING WHEEL ASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REMOVAL › 4.REMOVE STEERING WHEEL ASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
4.REMOVE STEERING WHEEL ASSEMBLY

45100
4.REMOVE STEERING WHEEL ASSEMBLY
5.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a. Check the check window shown in the illustration. With the steering wheel straight ahead, align the matchmarks to check the U-turn point of the cable from the check window.

NOTICE: When the conditions above cannot be checked via the check window with the front wheels facing straight ahead, there may be a malfunction in the spiral cable sub-assembly. In this case, replace the spiral with cable sensor sub-assembly with a new one.
*a Check Window *b Matchmark
U-Turn Point
45287
6.REMOVE LOWER STEERING COLUMN COVER
45286B
7.REMOVE UPPER STEERING COLUMN COVER
8.REMOVE SPIRAL CABLE SUB-ASSEMBLY
NOTICE:
· Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch ON.
· Do not rotate the spiral cable sub-assembly with the battery connected and the ignition switch ON.
· When rotating the spiral cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.
a. Slide the slider to release the lock, and then disconnect the airbag connector.
Parts & tools for this job For Toyota Hilux
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Toyota power steering fluid
As an Amazon Associate we earn from qualifying purchases.