STEERING GEAR - INSPECTION - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- INSPECTION › STEERING GEAR - INSPECTION - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
STEERING GEAR - INSPECTION

STEERING GEAR / LINKAGE STEERING GEAR INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
· When using a vise, place aluminum plates between the part and vise.
· When using a vise, do not overtighten it.
HINT:
· Use the same procedure for RHD and LHD vehicles.
· The procedure listed below is for LHD vehicles.
PROCEDURE
1.INSPECT TIE ROD END SUB-ASSEMBLY
a. Move the ball joint stud back and forth 5 times as shown in the illustration, before installing the nut.

b. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn. Standard turning torque:
0.5 to 3.5 N*m (6 to 35 kgf*cm, 5 to 30 in.*lbf) If the turning torque is not within the specified range, replace the tie rod end sub-assembly with a new one.
2.INSPECT POWER STEERING LINK ASSEMBLY
a. Using SST, check that the steering rack boots stretches smoothly when the control valve shaft is being rotated. SST 09616-00011 If there is any abnormality, replace the steering rack end boots with a new one.

Parts & tools for this job For Toyota Hilux
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Toyota power steering fluid
As an Amazon Associate we earn from qualifying purchases.