Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
NOTE: Do not heat the moulding excessively.
c. Using a scraper, pull off the roof drip side moulding from the front and rear ends.
HINT: Tape the scraper tip before use.
3. REMOVE ROOF DRIP SIDE MOULDING
a. Pull off the moulding by cutting the adhesive with a knife at the front and rear ends.
b. Remove the moulding.
NOTE: Do not damage the body with the knife.
INSTALLATION
1. CLEAN CONTACT SURFACE OF BODY
a. Using a heat light, heat the moulding surface to 40 - 60 °C (104 - 140 °F).
NOTE: Do not heat the body excessively.
b. Using a knife, cut away any rough areas on the body.
NOTE: Be careful not to damage the body.
c. Wipe off stains with cleaner.
2. If reusing the moulding: CLEAN MOULDING
a. Using a heat light, heat the moulding surface to 20 - 30 °C (68 - 86 °F).
NOTE: Do not heat the moulding excessively.
b. Using a knife, cut the remaining adhesive from the moulding.
NOTE: Be careful not to damage the moulding.
c. Wipe off stains with cleaner.