Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
d. Apply a new adhesive tape to the moulding as shown in the illustration.
3. COAT CONTACT SURFACE OF BODY WITH PRIMER "M".
Using a brush, coat the contact surface on the body with Primer M as shown in the illustration.
NOTE:
-
Allow 3 minutes or more to dry the primer coated surface.
-
Do not coat the adhesive.
-
Do not keep any of the opened Primer M for later use.
4. APPLY ADHESIVE
a. Cut off the tip of cartridge nozzle.
Part No. 08850 - 00801 or equivalent.
HINT: After cutting off the tip, use all adhesive within the time described in the table.
b. Load the cartridge into the sealer gun.