Body EquipmentControl unit, replace
 Remove, Disconnect Shell (glass) - see operation "Shell (glass), replace", crank, cover sliding roof - see operation "Cover sliding roof, remove and install", headlining edge protector. | 
|
Moulded headlining - see operation "Moulded headlining, remove and install". Remove water drain hoses - not cemented. | 
|
Remove, Disconnect Operating unit - 2nd mechanic. Bolting diagram - Rockwell-Golde
|
Pos. |
Designation |
Bolts |
Thread |
|
1 |
support, front |
2 x |
M5 x 10 |
|
2 |
roof frame |
12 x |
M5 x 10 |
|
3 |
support, centre |
2 x |
M5 x 10 |
|
4 |
support, rear |
4x |
M5 x 10 |
| 
|
Bolting diagram - Tudor-Webasto
|
Pos. |
Designation |
Bolts |
Thread |
|
1 |
support, front |
2 x |
M5 x 10 |
|
2 |
roof frame |
12 x |
M5 x 10 |
|
3 |
support, centre |
2 x |
M5 x 10 |
|
4 |
support, rear |
4x |
M5 x 10 |
| 
|
 Install, Connect Operating unit in positioning pins - 2nd mechanic.
1 Positioning pin, front roof frame
2 Positioning pin, centre
Control unit - tightening torque 4 Nm.
Install, Connect Push on water drain hoses - do not cement. moulded headlining, headlining edge protector, cover sliding roof, crank, shell (glass). | 
|
|
|
| Related Literature Units |
|---|
| - | | | - | | | - | |
|
04 Body & interior
