vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Power Mirrors Inoperative > < Power Mirror Folding Malfunction

Astra J

Heated Mirrors Malfunction

Diagnostic Instructions

•  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
•  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
•  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information



Circuit
Short to Ground
Open/High Resistance
Short to Voltage
Signal Performance

Heated Mirror Element Control
1
1
2
-

Ground
-
1
-
-

1. Heated Mirror Inoperative

2. Heated Mirror Always On
 

Circuit/System Description

The rear defogger relay supplies voltage to the outside rearview mirror heater elements based on the current state of the rear window defogger. The relay supplies B+ through the driver/passenger mirror heating element control circuit when a request is seen.

Reference Information


Schematic Reference

Outside Rearview Mirror Schematics


Connector End View Reference

Component Connector End Views


Description and Operation

Outside Mirror Description and Operation


Electrical Information Reference


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

1. Engine running, press the rear window defogger switch. Verify the rear window defogger turns ON and the rear window becomes warm.
⇒ If the rear window defogger does not turn on, refer to Rear Window Defogger Malfunction .
2. Verify both the left and right outside mirror glass become warm.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the appropriate A9 outside rearview mirror.
2. Wait 1 minute, test for less than 10 Ω between the ground circuit terminal 7 and ground.
⇒ If greater than the specified range, test the ground circuit for an open/high resistance.
3. Connect a test lamp between the heater element control circuit terminal 6 and ground.
4. Engine running, operate the rear window defogger ON and OFF with the rear defogger switch. The test lamp should turn ON and OFF when changing between the commanded states.
⇒ If the test lamp is always ON, test the control circuit for a short to voltage.
⇒ If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance.
5. If all circuits test normal, test or replace the outside rearview mirror glass.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Outside Rearview Mirror Glass Replacement

Power Mirrors Inoperative > < Power Mirror Folding Malfunction