vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
DTC C0000 > < DTC C0131

Astra J

DTC C0280

Diagnostic Instructions

    •  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    •  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0280 00:  Stability System Active Too Long

Circuit/System Description

The solenoid valves are integral parts of the brake pressure modulator valve assembly. The brake pressure modulator valve assembly contains an isolation solenoid valve and a dump solenoid valve for each wheel and a traction control/stability control supply solenoid valve and isolation solenoid valve for each brake circuit. The solenoid valves are not engaged during normal system operation. When the ABS, traction control or stability control operation is required the electronic brake control module (EBCM) turns the required solenoid valves ON.

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

Stability control is active for more than 15 s.

Action Taken When the DTC Sets

    •  The EBCM disables the stability control for the duration of the ignition cycle.
    •  The traction control/stability control-active indicator turns ON.

Conditions for Clearing the DTC

The condition for setting the DTC is no longer present.

Diagnostic Aids

DTC can set because of extended operation of ABS, traction control or stability control.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Testing

  1. Ignition ON, verify that DTC C0186, C0196, C019B, or C0710 is not set as a present DTC.
    2. ⇒ If any listed DTC is present, refer to Diagnostic Trouble Code (DTC) List - Vehicle to diagnose that DTC prior to this diagnostic.
  2. Inspect the B99 Steering Wheel Angle Sensor and B119 Multi-axis Acceleration Sensor for correct installation.
    3. ⇒ If loose or incorrect installation is diagnosed, correct the installation of the component.
  3. Ignition ON, verify that DTC C0280 00 is not set as a present DTC.
    4. ⇒ If DTC C0280 00 is present, replace the K17 Electronic Brake Control Module (EBCM) and verify the DTC does not reset. If the DTC resets replace the brake pressure modulator valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Control Module References for EBCM replacement, setup and programming

DTC C0000 > < DTC C0131