Diagnostic NavigationDiagnostic Repair Verification
Diagnostic Repair Verification
Note: After a repair has
been made, some DTCs require the ignition to be turned OFF then
back ON before the scan tool function will clear the DTC.
| 2. |
Install any components or
connectors that have been removed or replaced during
diagnosis. |
| 3. |
Perform any adjustment,
programming or setup procedures that are required when a component
or module is removed or replaced. |
| 6. |
Turn the ignition OFF for 60
seconds. |
| 7. |
If the repair was related to a
DTC, duplicate the Conditions for Running the DTC and use the
Freeze Frame/Failure Records, if applicable, in order to verify the
DTC does not reset. If the DTC resets or another DTC is present,
refer to the
Diagnostic Trouble Code (DTC) List - Vehicle and perform the
appropriate diagnostic procedure. |
| |
If the repair was symptom related, duplicate the conditions
under which the customer concern occurred to verify the repair. If
the customer concern reoccurs or another symptom is present, return
to
Symptoms - Vehicle and perform the appropriate symptom
diagnostic. |
|
|
08 Diagnostics
