Workshop Manuals Factory service & repair Vauxhall
01 Preface02 General Information03 Body Hardware and Trim04 Body Repair05 Body Systems06 General Vehicle Information07 Brakes08 Diagnostic Navigation09 Driveline/Axle10 Driver Information and Entertainment11 Engine12 HVAC13 Power and Signal Distribution14 Roof15 Safety and Security16 Seats17 Steering18 Suspension19 Transmission/Transaxle
Vauxhall Astra J11 · Engine
11 · Engine

DTC P0703

Make
Vauxhall
Model
Astra J
Section
Diagnostic Information and Procedures › Miscellaneous › DTC P0703
EngineDTC P0703

DTC P0703

Diagnostic Instructions

•  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
•  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
•  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0703: Brake Switch Circuit 2

Circuit/System Description

The body control module (BCM) monitors the brake pedal position sensor. When the brake pedal is applied, the BCM detects a predetermined voltage signal. The BCM sends a serial data message to the engine control module (ECM) indicating the status of the stop lamps.

Conditions for Running the DTC

The engine is ON.

Conditions for Setting the DTC

•  The ECM receives an invalid brake pedal status serial data message from the BCM.
•  This diagnostic runs continuously.

Action Taken When the DTC Sets

•  The malfunction indicator lamp (MIL) will not illuminate.
•  The cruise control system is disabled.

Conditions for Clearing the DTC

•  The condition responsible for setting the DTC no longer exists.
•  A history DTC will clear after 40 malfunction-free ignition cycles have occurred.

Reference Information


Schematic Reference

Cruise Control Schematics


Connector End View Reference

Component Connector End Views


Description and Operation

Cruise Control Description and Operation


Electrical Information Reference


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

1. Verify that DTC P0572 or P0573 is not set.
⇒ If DTC is set, refer to Diagnostic System Check - Vehicle .
2. Verify that DTC P0703 is not set.
⇒ If DTC is set, replace the K9 Body Control Module. Clear the DTC and road test the vehicle. If DTC resets, replace the K20 Engine Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for control module replacement, setup and programming

Parts & tools for this job For Vauxhall Astra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.