DTC B1516 08: Battery Current Sensor Signal
Invalid
DTC B1516 66: Battery Current Sensor Wrong
Mounting Position
Diagnostic Fault Information
Circuit
Short to Ground
Open/High Resistance
Short to Voltage
Signal Performance
5 V Reference
B1516 08
B1516 08
-
-
Signal
B1516 08
B1516 08
B1516 08
B1516 08, B1516 66
Low Reference
-
B1516 08
-
-
Circuit/System Description
The battery current sensor is a 3-wire hall effect current
sensor. The body control module (BCM) supplies 5 V and ground to
the battery current sensor. The battery current sensor measures the
amount of current flowing to or from the battery, and supplies a
pulse width modulation (PWM) signal to the BCM.
Conditions for Running the DTC
B1516 08
The BCM is awake.
B1516 66
•
The BCM is awake.
•
The engine is OFF.
Conditions for Setting the DTC
B1516 08
The battery current signal is less than 4 percent or greater than
96 percent duty cycle for 2 minutes.
B1516 66
The battery current polarity is positive for 2 minutes.
Action Taken When the DTC Sets
The regulated voltage control (RVC) is disabled.
Conditions for Clearing the DTC
The DTC passes when the battery current returns to the normal
range for 15 seconds.
Diagnostic Aids
DTC B1516 08 could be set by overcharging with a battery charger
or jump starting.
Ignition OFF, disconnect the
harness connector at the B18 battery current sensor.
2.
Ignition OFF and scan tool
disconnected, open and close the driver door, and wait 1 minute.
Test for less than 30 Ω between the low reference circuit
terminal B and ground.
⇒
If greater than specified range , test the low
reference circuit for an open/high resistance. If the circuit tests
normal, replace the K9 BCM.
3.
Ignition ON, test for 4.8-5.2
V between the 5 V reference circuit terminal A and ground.
⇒
If less than the specified range , test the 5 V
reference circuit for a short to ground or an open/high resistance.
If the circuit tests normal, replace the K9 BCM.
⇒
If greater than the specified range, test the 5 V
reference circuit for a short to voltage. If the circuit tests
normal, replace the K9 BCM.
4.
Ignition ON, test for 4.8-5.2
V between the signal circuit terminal C and ground.
⇒
If less than the specified range, test the signal
circuit for a short to ground or an open/high resistance. If the
circuit tests normal, replace the K9 BCM.
⇒
If greater than the specified range, test the
signal circuit for a short to voltage. If the circuit tests normal,
replace the K9 BCM.
5.
If all circuits test normal,
test or replace the B18 battery current sensor.
B1516 66
1.
Verify that the B18 battery
current sensor is installed securely around the negative battery
cable, with the tape tab pointing away from the negative terminal
on the C1 battery.
⇒
If the B18 battery current sensor is not installed
correctly, remove and reinstall the sensor properly.
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.
Help keep workshop manuals free
workshop-manuals.com provides free online workshop manuals.
If they helped you fix your car, please consider sharing or
making a small donation to keep the servers running.