DTC C0870 03: Control Module Voltage Reference
Output Circuit Low Voltage
DTC C0870 07: Control Module Voltage Reference
Output Circuit High Voltage
Diagnostic Fault Information
Circuit
Short to Ground
Open/High Resistance
Short to Voltage
Signal Performance
5V Reference
C0870 03
C0595 05, C0600 05, C0605 05, C0670 05, C0675 05
C0870 07
-
Low Reference
-
C0595 05, C0600 05, C0605 05, C0670 05, C0675 05
-
-
Circuit/System Description
The suspension control module supplies a 5 V reference voltage
and a low reference to each body acceleration sensor and wheel
acceleration sensor. The body acceleration sensors and wheel
acceleration sensors supply a signal of 0.5-4.5 V to the suspension
control module.
Conditions for Running the DTC
System voltage is between 9-16 V
Conditions for Setting the DTC
C0870 03
The suspension control module detected a short to ground on the 5 V
reference circuit for 1.5 seconds
C0870 07
The suspension control module detected a short to voltage on the 5
V reference circuit for 1.5 seconds
Action Taken When the DTC Sets
•
The electronic suspension
control is disabled for the duration of the ignition cycle.
•
The driver information center
displays the SERVICE SUSPENSION SYSTEM message
Conditions for Clearing the DTC
•
A present DTC will clear on
the next consecutive malfunction-free ignition cycle.
•
A history DTC will clear after
41 consecutive malfunction-free ignition cycles.
Ignition ON, observe the scan tool Suspension Position Sensor 5
V Reference parameter. The reading should be 5 V.
Circuit/System Testing
1.
Ignition OFF, disconnect the
harness connectors at all 5 vertical body and wheel acceleration
sensors.
2.
Ignition ON, test for 4.8-5.2
V between one of the 5 V reference circuits terminal 1 and
ground.
⇒
If less than the specified range, test the 5 V
reference circuit for a short to ground. If the circuit tests
normal, replace the K19 Suspension Control Module.
⇒
If greater than the specified value, test the 5 V
reference circuit for a short to voltage. If the circuit tests
normal, replace the K19 Suspension Control Module.
3.
Test for 4.8-5.2 V between all
5 vertical body and wheel acceleration sensor signal circuit
terminals 2 and ground.
⇒
If less than the specified value, test the signal
circuit for a short to ground or an open/high resistance. If the
circuit tests normal, replace the K19 Suspension Control
Module.
⇒
If greater than the specified value, test the
signal circuit for a short to voltage. If the circuit tests normal,
replace the K19 Suspension Control Module.
4.
Ignition OFF, connect each
component associated with the 5 V reference circuit one at a time
while observing the scan tool Suspension Position Sensor 5 V
Reference parameter. Verify the reading is 5 V.
⇒
If not the specified value when a component is
connected, replace the component.
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.
Help keep workshop manuals free
workshop-manuals.com provides free online workshop manuals.
If they helped you fix your car, please consider sharing or
making a small donation to keep the servers running.