SteeringUpper Steering Shaft, Replace
|
Upper Steering Shaft, Replace
Caution
Before removal of the steering wheel in vehicles with airbag,
make sure that the steering is placed in straight ahead position
and is locked with the steering lock.
 Remove
Remove steering wheel – see operation "Steering Wheel
and/or Slip Ring, Replace (Vehicles without Airbag)" or "Steering
Wheel, Remove and Install (Vehicles with Airbag)".
|
Unclip drivers side footwell panelling. Remove footwell
ventilation duct. Remove clamping screw (1) from disc joint.
In vehicles with airbag: remove contact unit – see
operation "Airbag Contact Unit, Remove and Install" in group
"C".
|
|
|
Unfasten fastening screws (1) and fastening screws (2) of the
signal switch housing and remove the two part signal switch
housing. Unclip signal and wiper switch.
|
|
|
Lever upper and lower housing plugs (1) from switch housing,
turn switch housing to left and remove. Disconnect lock cylinder
and wiring harness plug for steering and ignition lock – see
operation "Lock Cylinder for Steering and Ignition Lock, Remove and
Install" in group "N". Pull steering shaft from steering
column.
Install
Slightly widen clamp of disc joint. Carefully insert steering
shaft in steering column. Connect switch housing. Clip signal and
wiper switch in. Bolt signal switch panelling on. Install lock
cylinder for steering and ignition lock – see operation "Lock
Cylinder for Steering and Ignition Lock, Remove and Install" in
group "N".
In vehicles with Airbag: install contact unit – see
operation "Airbag Contact Unit, Remove and Install" in group
"C".
Install steering wheel – see operation "Steering Wheel
and/or Slip Ring, Replace (Version without Airbag)" or "Steering
Wheel, Remove and Install (Vehicles with Airbag)". Install
ventilation duct, footwell panelling.
|
|
|
|
| Related Literature Units |
|---|
| - | | | - | | | - | | | - | | | - | | | - | |
|
12 Steering & suspension
