940 L4-2.3L SOHC VIN 88 B230F (1992)
P7. Before installing master cylinder: Check distance between end of servo pushrod and face of servo as illustrated
Dimension should be as follows in mm (inch):
P8. Install master cylinder
Tighten nuts to max. 23 Nm (17 ft. lbs.).
Reconnect brake pipes.
If car is equipped with hydraulic clutch: Reconnect clutch hose to reservoir.
Fill with genuine Volvo brake fluid.
P9. Bleed braking system and clutch (as applicable).
P10. Pressure-test braking system
Pressure-test braking system after bleeding. Operate brake pedal with a force equivalent to hard braking for 30 seconds and inspect master
cylinder for signs of fluid leakage.
Note: Pedal travel must not exceed 55 mm (2.2 inch) when pedal is operated at least 3 - 4 times with engine stopped.
Note: If brake warning light operates when pressing brake pedal, Replace Pressure Differential Warning Valve.
Note: This application only applies to vehicles that are not equipped with ABS and are no later than 1988 model year cars.