940 L4-2.3L SOHC VIN 88 B230F (1992)
Raise heating duct slightly using a screwdriver and remove cable.
Installation
(A15)
Raise heating duct slightly
Use screwdriver to lift. Thread new cable under duct.
(A16)
Connect cable adjuster at gear lever end
Install locking clip.
(A17)
Ensure that gear selector lever is in position P
Press in locking tab on cable end so that cable can be hooked more easily to operating arm in gear lever mechanism. Release locking tab.
Note:
Ensure that ball on cable end is properly seated.
(A18)
Move gear selector lever to position other than P