940 L4-2.3L SOHC VIN 88 B230F (1992)
-
Place seal on tool 5538 (against side marked 1031).
-
1 = Seal.
-
Press on seal using tool 5156 (M20 thread) or 5504 (M24 thread).
-
Install drive flange, oiled on the seal surface using press tool, positioning flange as per marking.
-
Torque drive flange. Use new, oiled nut.
NOTE: Do not use nut runner.
Pinion without compression sleeve: 200 - 250 Nm (148 - 184 ft lb).
Pinion with compression sleeve: 180 - 200 Nm (133-148 ft lb).
No axial play is permissible.
NOTE: A torque of 200 Nm (148 ft lb) must not be exceeded. Otherwise, the pinion bearing preload may be excessive, leading to bearing failure.
-
Install propeller shaft as per marking. Use new bolts and nuts.
-
Tighten nuts in diagonal pattern to 50 Nm (37 ft lb).
-
Check oil level.