XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Note! The small thicker and stiffer orange cables in the cable harnesses are fibre optic and must be handled and routed very carefully. These
cables cannot be bent as much as normal wiring, the bend radius must not be less than 3 cm.
Applies to cars without a factory installed player, when only installing a MiniDisc player
-
Take the junction cable (A) from the kit (purchased separately)
-
Connect the connect (1) on the junction cable to the corresponding connector on the MiniDisc player.
Note! Be very careful when connecting the connector in the MiniDisc player. The terminal pins in this connector are thin. They are easily
damaged and may become pressed into the player if the connector is not installed straight.
-
Locate the pre-routed, bridge connector (2) on the fibre optic cable in the centre console, wrapped in foam tape
-
Disconnect the connector (3) from the bridged connector (2). Connect it to connector (4) on the junction cable.
Note! If installing a MiniDisc player and an RTI system at the same time, the junction cable for the RTI system must be connected first to
the connector (3). This connector will then be in use, but there is a corresponding connector on the junction cable for the RTI system.
Connect this to the connector (4).
-
Find the pre-routed grey connector (5) for power supply in the thick cable harness in the centre console. The connector is located either in the
centre console or in the space above the accelerator pedal. To remove the panel above the accelerator panel, slacken off the two Torx screws and
then pull the panel free from the clips on the outer edges and unhook it
-
Connect the connector (5) to the remaining connector (6) on the junction cable
-
Take half of the foam tape from the wiring kit and wrap it around the grey connectors (5, 6). Use the remaining foam tape to tape around the
connectors (3, 4).
Note! The junction cable must be routed around the bracket as illustrated. When reinstalling the bracket in the centre console in the car,
the junction cable must be held against the bracket as illustrated. This is to ensure that it remains in position.
Applies to cars without a factory installed player, when installing both a MiniDisc and CD player/changer
-
Take out the junction cable (B) (purchased separately) with the four connectors
-
Connect the connector (1) on the junction cable to the corresponding connector on the MiniDisc player and connector (2) to the corresponding
connector in the CD player/changer. The connectors (1) and (2) are identical. It does not matter which connector is connected to which unit.
