XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Note! Be very careful when connecting the connectors in the MiniDisc/CD players. The terminal pins in these connectors are thin. They
are easily damaged and may become pressed into the players if the connector is not installed straight.
-
Locate the pre-routed, bridge connector (3) on the fibre optic cable in the centre console, wrapped in foam tape
-
Disconnect the connector (4) from the bridged connector (3). Connect it to connector (5) on the junction cable.
Note! If installing a MiniDisc player and an RTI system at the same time, the junction cable for the RTI system must be connected first to
the connector (4). This connector will then be in use, but there is a corresponding connector on the junction cable for the RTI system.
Connect this to the connector (5).
-
Find the pre-routed grey connector (6) for power supply in the thick cable harness in the centre console. The connector is located either in the
centre console or in the space above the accelerator pedal. To remove the panel above the accelerator panel, slacken off the two Torx screws and
then pull the panel free from the clips on the outer edges and unhook it
-
Connect the connector (6) to the remaining connector (7) on the junction cable
-
Take half of the foam tape from the wiring kit and wrap it around the grey connectors (6, 7). Use the remaining foam tape to tape around the
connectors (4, 5).
Note! The junction cable must be routed around the bracket as illustrated. When reinstalling the bracket in the centre console in the car,
the junction cable must be held against the bracket as illustrated. This is to ensure that it remains in position.
Operations 10-14 apply to cars with factory-installed CD players/changers
Note! If installing a MiniDisc player and an RTI system at the same time, the RTI system must be connected according to the installation
instructions. Then follow these installation instructions as if the RTI system was not installed. However use the connector in the CD
player/changer.
Hint: work from the right-hand seat.
-
Remove approximately 20 cm of foam tape from the existing cable harness so that the wiring is unimpeded
-
Reinstall the connectors for the control module and the dashboard environment panel. Do not connect the connector (1) to the CD player yet.
