Workshop Manuals Factory service & repair Alfa Romeo
01 Introduction and contents02 Technical data and maintenance03 Engine04 Clutch05 Gearbox06 Front axle and drive shafts07 Brakes08 Steering09 Suspension and wheels10 Heating and ventilation11 Bodywork12 Timing belt data sheets
Alfa Romeo 145/146 Factory Service Manual (1994-1999)11 · Bodywork
11 · Body & interior

Boot

Make
Alfa Romeo
Model
145/146 Factory Service Manual
Year
1994–1999
Section
Bonnet / boot › Boot
BodyworkBoot · page 1 of 2

BOOT

REMOVAL/REFITTING

  • Disconnect the negative cable (-) from the battery.
  1. Open the boot. Pull off and remove the two side trim panels from the plastic buttons.
Pulling off the boot side trim panel 1 with a screwdriver
  1. Remove the two bulb access panels.
  2. Loosen the two screws securing the boot's interior trim.
Bulb access panel 1 and trim securing screw 2
  1. Pull the trim away from the plastic buttons in the lower part of the boot and remove.
Boot lid with the lower trim 1
  1. Pull the trim away from the plastic buttons (positioned as shown in the diagram) in the upper part of the boot and remove.
Upper boot trim 1 with the plastic button positions
  1. Disconnect the electrical connections from the reversing lights and the rear fog lights.
Electrical connections 1 of the reversing and rear fog lights
  1. Disconnect the electrical connection from the centralized locking.
  2. Disconnect the electrical connection from the rear windscreen wiper.
Centralized locking connection 1 and rear windscreen wiper connection 2

Parts & tools for this job For 1994 Alfa Romeo 145/146

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.