Workshop Manuals Factory service & repair Alfa Romeo
01 General data and specifications02 Maintenance03 Diagnosis – checks04 Engine (1.6 and 2.0 Twin Spark)05 Clutch06 Gearbox (manual and Selespeed)07 Front axle08 Brakes, ABS and traction control09 Steering10 Suspension and wheels11 Heating, air conditioning and washers12 Electrical equipment13 Body14 Body panels and reinforcement15 Wiring diagrams16 Connectors and pin-outs17 Wiring harnesses18 Fault diagnosis19 Special tools
Alfa Romeo 147 Factory Service Manual (2000-2002)18 · Fault diagnosis
18 · Diagnostics

X05 Excessive oil consumption

Make
Alfa Romeo
Model
147 Factory Service Manual
Year
2000–2002
Section
Consumption / leaks / wear › X05 Excessive oil consumption
Fault diagnosisX05 Excessive oil consumption

X05 Excessive oil consumption

NOTA: High consumption during the first few thousand kilometres is considered normal.

StepTest procedureResultAction
0PRELIMINARY CHECKS

Check that the level of the engine oil is not high Op. 1048A10

Check that there is no engine oil in the coolant

Check that the end of the exhaust pipe is not dirty with oil

Check whether there is blueish smoke in the exhaust

Carry out a consumption test

OK

Move onto step 1

Engine oil leaks

End of diagnosis

Oil level outside the limits

End of diagnosis

Oil level outside the limits

Move onto step 2

Oil level outside the limits

Move onto step 2

Oil level outside the limits

Move onto step 2

Oil level outside the limits

Move onto step 2

1SPARK PLUG CHECK

Check that there is no oil fouling the spark plugs

OK

Move onto step 2

Spark plugs fouled by oil

Move onto step 2

2CYLINDER BLOCK/CRANKASE SURFACE CHECK

Remove the cylinder head Op. 1016C10

That that the following are absent:

  • oily deposits on the valves;
  • defects in the cylinder block/crankcase surface;
  • defects in the cylinder head gasket;
OK

Move onto step 3

Cylinder block/crankcase surface defective
  • Reface the cylinder block/crankcase

End of diagnosis

Oily deposits on the valves

End of diagnosis

3CYLINDER LINER/BORE CHECK

Check the cylinder liners/bores. In particular:

  • no deep machining scoring;
  • no vitrification of the liners/bores;
  • make sure that there is no ovality or wear
OK

Move onto step 4

Deep scoring or excessive ovality

End of diagnosis

Deep scoring or excessive ovality
  • Regrind the cylinder

End of diagnosis

Deep scoring or excessive ovality
  • Regrind the cylinder

End of diagnosis

Deep scoring or excessive ovality

End of diagnosis

4CHECK ON CORRECT OPERATION

Check that the fault is no longer present

OK

Incorrect selection of diagnostic procedure

Fault persists

Incorrect selection of diagnostic procedure

Parts & tools for this job For 2000 Alfa Romeo 147

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.