VACUUM PIPE COMPLETE WITH SINGLE -ACTING VALVES RR

Operation 3330D28 · BRAKE VACUUM SYSTEM

1.8 T.SPARK, 2.0 JTS

Removing

Proceed with removal

Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R

1. Loosen the band and disconnect the vacuum pipe from the air chamber.

2. Disconnect the rapid connector for the vacuum pipe from the pressure sensor on the brake servo.

3. Disconnect the intermediate rapid connector for the vacuum pipe.

4. Remove the vacuum pipe complete with single-acting valves (4a) after having released it from the band (4b).

Refitting

Place the vacuum pipe, complete with single-acting valves, back in its housing and secure it to the band.

Connect the intermediate rapid connector for the vacuum pipe.

Connect the rapid connector for the vacuum pipe to the pressure sensor on the brake servo.

Connect the vacuum pipe to the air chamber and tighten the band.

Proceed with refitting

Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R.