Vacuum SENSOR on brakeservo RR
- Make
- Alfa Romeo
- Model
- GT Factory Service Manual
- Year
- 2003–2010
- Section
- Hydraulic braking system › Vacuum SENSOR on brakeservo RR
Vacuum SENSOR on brakeservo RR
Removing
Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).
| Name | Connector | |
|---|---|---|
| Battery | See A1B BATTERY ( BATTERY NEGATIVE ) |
1. Disconnect the electrical connection from the vacuum sensor on the brake servo.
| Name | Connector | |
|---|---|---|
| 1 | Brake servo vacuum unit sensor | See K105 BRAKE SERVO VACUUM UNIT SENSOR |
2. Disconnect the rapid connector for the vacuum pipe from the pressure sensor on the brake servo.
3. Undo the bolt (3a) and remove the vacuum sensor on the brake servo (3b).
Refitting
Place the vacuum sensor back in its housing on the brake servo and secure it using the bolt.
Connect the rapid connector for the vacuum pipe to the pressure sensor on the brake servo.
Connect the electrical connection to the vacuum sensor on the brake servo.
Connect the negative (-) battery terminal
Parts & tools for this job For 2003 Alfa Romeo GT
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.