Remove

Remove

1. Disconnect the vehicle battery at the negative terminal and ensure the ignition key is removed.

⚠ Warning ⚠
Allow a two minute power down period before proceeding. This will ensure that there is no power to the deployable rollbar system.

2. Remove the boot trim to gain access to the rollbar sensor unit.
3. Remove the bolts (x4) that secure the rollbar sensor and bracket assembly.
4. Withdraw the rollbar sensor and bracket assembly to access the wirining harness plug. Disconnect the wiring harness plug.
5. Remove the rollbar sensor unit from its bracket (screws x3).

Install

⚠ Warning
Do not connect the vehicle battery unitll the rollbar sensor is fully installed.

⚠ Warning ⚠
Allow a two minute power down period before proceeding. This will ensure that there is no power to the deployable rollbar system.

1. Install the deployable rollbar sensor unit to it’s bracket. Torque bolts (x3) to TBA Nm.
2. Connect the wiring harness plug.
3. Install the bolts (x4) that secure the rollbar sensor and bracket assembly. Torque to TBA Nm.
4. Install the boot trim.
5. Connect the vehicle battery at the negative terminal.