Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Removing-refitting timing belt (page 2 of 2)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Replacing timing belt (1929 D)
10 EngineRemoving-refitting timing belt · page 2 of 2
Diagram showing alignment marks on the crankshaft pulley and a tool engaging with the engine block
Diagram showing alignment marks on the timing belt gear and flywheel housing
Diagram showing a flywheel retainer tool (part no. 1860766000) positioned against the engine block, with an inset view of the tool
  1. Check that the notch on the timing system drive gear is aligned with the hole on the rear timing belt cover. Also check that the notch on the gearbox bell housing is aligned with the reference mark on the fly-wheel.
  2. Check that the notch on the injection pump pulley is aligned with the reference mark on the rear toothed timing belt cover.

When fitting the timing belt, take care to fit the belt without moving the pulley out of position (with reference marks aligned).

  1. Position flywheel retainer 1860766000 to prevent the crankshaft from turning.
  2. Remove alternator - coolant pump damping drive pulley.
Diagram showing a wrench being used to remove the alternator and coolant pump damping drive pulley from the engine

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.